Ford Explorer: Body and Paint / Handles, Locks, Latches and Entry Systems

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Handles, Locks, Latches and Entry Systems

Removal and Installation - Overhead Console

Special Tool(s) / General Equipment Interior Trim Remover Removal Starting at the back, release the clips and remove the overhead console...

Description and Operation - Handles, Locks, Latches and Entry Systems - Component Location

..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Seat Position Sensor


Removal NOTE: Typical LH (left-hand) seat shown, RH (right-hand) seat similar. NOTE: Removal steps in this procedure may contain installation details. Raise the seat to the full up position. Disconnect the electrical connector...

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Fuel Rail


Special Tool(s) / General Equipment 303-1567Sizer, Teflon SealTKIT-2010C-FLM 307-005 (T59L-100-B) Slide Hammer 310-205Fuel Injector Brush 310-206Remover, Fuel InjectorTKIT-2009A-FLM 310-207Installer, Fuel Injector Seal AssemblyTKIT-2009A-FLM Removal NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances...

Categories

Integrated Keyhead Transmitter (If Equipped)

Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle. The integrated keyhead transmitter functions as a programmed ignition key that operates all the locks and starts your vehicle, as well as a remote control.

read more

 
Copyright © 2026 www.foexplorer.com