Ford Explorer: Handles, Locks, Latches and Entry Systems / General Procedures - Staged Unlock Programming
Activation
-
With the ignition in OFF, press the LOCK and UNLOCK buttons on the RKE transmitter simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
-
Repeat these steps to enable/disable the staged unlocking feature.
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Interior Trim Remover
Activation
Remove the liftgate latch access cover from the center of the liftgate trim pane..
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Repair individual door lock cylinders by discarding the
inoperative door lock cylinder and building a new door loc..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The SCMJ (power fold seat module) is located under the LH (left-hand) second row seat cushion frame.
NOTE:
This step is only necessary when installing a new component...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
If installing a new BCM, connect a battery charger to the battery to make sure it is charged to maintain proper battery voltage.
Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures)...
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more