Kia Picanto: Interior Trim and Ornamentation / Removal and Installation - Front Scuff Plate Trim Panel
Special Tool(s) /
General Equipment
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
Left hand side
-
Remove the hood latch release handle.
Refer to: Hood Latch Release Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
All vehicles
-
Remove the front door scuff plate trim panel.
-
Release the clips.
Use the General Equipment: Interior Trim Remover
-
If equipped.
Disconnect the front door scuff plate trim panel electrical connector.
Installation
-
To install, reverse the removal procedure.
-
Inspect and position the front door weather strip lip so
that it overlaps the top of the front scuff plate trim panel.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
NOTE:
Removal steps in this procedure may contain installatio..
Special Tool(s) /
General Equipment
Pick Hook
Interior Trim Remover
Materials
Name
Specification
3M™ Super-Fast Repair Adhesive04747
-
Removal
Remove the..
Other information:
Special Tool(s) /
General Equipment
Vehicle/Axle Stands
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense...
Special Tool(s) /
General Equipment
303-1521Alignment Tool, Crankshaft Position SensorTKIT-2010C-FLM
303-1686Holding Tool, Camshaft
303-1689Holding Tool, Crank Damper
303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESE-M1C171-A
..
Categories
Note: You may not be able to shift out of park (P) unless the intelligent
access key is inside your vehicle.

read more