Ford Explorer: Body and Paint / Interior Trim and Ornamentation

Removal and Installation - Rear Gate Trunk Module (RGTM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component...

Removal and Installation - A-Pillar Trim Panel

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: LH (left hand) shown, RH (right hand) similar. Disconnect the tether clips from the A-pillar trim pa..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Liftgate Moulding

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Disconnect the washer hose and the electrical connector...

Ford Explorer 2020-2026 Service Manual: General Procedures - Cylinder Block Distortion

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent...