Kia Picanto: Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Rear Antenna
Special Tool(s) /
General Equipment
Removal
-
Position the liftgate weatherstrip aside.
-
Remove the liftgate scuff plate trim panel.
-
Release the liftgate scuff plate trim panel clips.
Use the General Equipment: Interior Trim Remover
-
Disconnect the keyless entry rear antenna electrical connector.
-
Remove the keyless entry rear antenna.
-
Remove the keyless entry rear antenna nuts.
-
Remove the keyless entry rear antenna.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
Remove the front door upper moulding...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Re..
Other information:
Special Tool(s) /
General Equipment
303-1252Stretchy Belt Remover/ Installer ToolTKIT-2006UF-FLMTKIT-2006UF-ROW
Removal
NOTICE:
Under no circumstances should the accessory drive belt,
tensioner or pulleys be lubricated as potential damage to the belt
material and tensioner damping mechanism will occur...
Before exporting your vehicle to a foreign country, contact the appropriate foreign
embassy or consulate. These officials can inform you of local vehicle registration
regulations and where to find unleaded fuel or petrol/gas engines or the proper
sulfur fuel for diesel engines...
Categories
Push the lever up or down to operate
the windshield wipers.

A - Single wipe.
read more