Ford Explorer: Suspension System - General Information / General Procedures - Rear Camber Adjustment

Ford Explorer 2020-2025 Service Manual / Chassis / Suspension / Suspension System - General Information / General Procedures - Rear Camber Adjustment

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

  1. Using alignment equipment and the manufacturer's instructions, measure the rear camber.
    Use the General Equipment: Wheel Alignment System

    1. Loosen the upper arm-to-frame bolt counterclockwise (CCW) through 2 complete turns.
      Torque: 129 lb.ft (175 Nm)
    1. Move the upper arm inboard or outboard to adjust rear camber as necessary.
  1. Recheck alignment to verify camber change and adjust rear toe if necessary.
    Refer to: Rear Toe Adjustment (204-00 Suspension System - General Information, General Procedures).

    General Procedures - Front Toe Adjustment

    Special Tool(s) / General Equipment Wheel Alignment System Adjustment NOTE: Make sure that the vehicle is standing on a level surface. NOTE: Before carrying out a toe adjustment,..

    General Procedures - Rear Toe Adjustment

    Special Tool(s) / General Equipment Wheel Alignment System Adjustment NOTICE: Do not use any tools or equipment to move the wheel and tire assembly or suspension components while che..

    Other information:

    Ford Explorer 2020-2025 Owners Manual: Automatic High Beam Control Indicators


    The indicator illuminates to confirm when the system is ready to assist. Overriding Automatic High Beam Control WARNING: The system does not relieve you of your responsibility to drive with due care and attention. You may need to override the system if it does not turn the high beams on or off...

    Ford Explorer 2020-2025 Service Manual: Removal and Installation - Rear Door Upper Moulding


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the upper belt moulding screw at front of the door. Torque: 12 lb.in (1.3 Nm) Lift the moulding at the front edge using a non-marring trim tool and slide forward to disengage from the tab at the rear and remove th..

    Categories

    Fastening the Seatbelts

    The front outboard and rear safety restraints in the vehicle are combination lap and shoulder belts.

    read more

     
    Copyright © 2025 www.foexplorer.com