Ford Explorer: Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Keypad

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Handles, Locks, Latches and Entry Systems / Removal and Installation - Keyless Entry Keypad

Removal

NOTE: The keyless entry keypad is serviced as an assembly with the front door upper moulding.

Remove the front door upper moulding.
Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

Installation

To install, reverse the removal procedure.

Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Removal and Installation - Interior Rear Door Handle

Removal NOTE: LH (left-hand) side shown, RH (right-hand) side similar. Remove the rear trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and In..

Removal and Installation - Keyless Entry Rear Antenna

Special Tool(s) / General Equipment Interior Trim Remover Removal Position the liftgate weatherstrip aside. Remove the liftgate scuff plate trim..

Other information:

Ford Explorer 2020-2026 Service Manual: General Procedures - Piston Diameter

Check Measure the piston diameter 90 degrees from the piston pin and piston diameter (DN) height down from the top of the piston at the point indicated. Refer to specifications for the piston diameter (DN) height. Refer to: Specifications (303-01A Engine - 2...

Ford Explorer 2020-2026 Service Manual: Description and Operation - Supplemental Climate Control - System Operation and Component Description

System Diagram Item Description 1 SOBDMC 2 BCMC 3 PCM 4 Cabin Coolant Heater 5 Cabin heater coolant temperature sensor 6 Cabin heater coolant pump 7 Ambient Air Temperature (AAT) sensor 8 Engine Coolant Temperature (ECT) sensor Network Message Chart - Module Network Input Messages - SOBDMC Cabin Coolant H..