Ford Explorer: Handles, Locks, Latches and Entry Systems / Removal and Installation - Liftgate Lock Cylinder - Police
Removal
NOTE:
Repair individual liftgate lock cylinder by discarding the
inoperative liftgate lock cylinder and building a new liftgate lock
cylinder using the appropriate lock repair service kit. The lock repair
service kit includes a detailed instruction sheet to build the new lock
to match the key cut pattern for the vehicle, thus allowing for single
point replacement without needing to replace or reprogram other locks or
keys.
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the electrical connector and position aside the wiring harness.
-
Remove the liftgate lock cylinder.
-
Remove the liftgate lock cylinder release cable from the liftgate lock cylinder.
-
Remove the liftgate lock cylinder.
Torque:
80 lb.in (9 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Re..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the liftgate moulding.
Refer to: Liftgate Moulding (501-08 Exterior Trim and Ornamentation, Removal and ..
Other information:
Programming
This procedure should be performed when a new
transmission or main control valve body is installed in the vehicle.
13 - digit solenoid body strategy
12 - digit solenoid body identification
If a new main control was installed, record the
13-digit solenoid body strategy from the replacement solenoid body tag
provided with the main control service kit...
Special Tool(s) /
General Equipment
Hydraulic Press
Removal
NOTICE:
Suspension fasteners are critical parts that affect
performance of vital components and systems. Failure of these fasteners
may result in major service expense. Use the same or equivalent parts if
replacement is necessary...
Categories
The front outboard and rear safety restraints in the vehicle are combination
lap and shoulder belts.

read more