Ford Explorer: Climate Control System - General Information / Removal and Installation - Blower Motor Control Module

Ford Explorer 2020-2026 Service Manual / Electrical / Climate Control System / Climate Control System - General Information / Removal and Installation - Blower Motor Control Module

Removal

Remove the push pins and the passenger side insulation panel.
- Disconnect the electrical connector.

Remove the screws and the blower motor control module.
- Disconnect the electical connector.

Installation

To install, reverse the removal procedure.

Removal and Installation - Ambient Air Temperature Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation)...

Removal and Installation - Cabin Air Filter

Removal Push the stop tabs inwards and fully lower the glove compartment. Remove the glove compartment check strap. Remove the screws and lower th..

Other information:

Ford Explorer 2020-2026 Service Manual: Diagnosis and Testing - Accessory Drive

Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical damage. Visual Inspection Chart Mechanical Damaged or contaminated accessory drive belt Damaged or contaminated pulley(s) Incorrect accessory drive belt Incorrect fitment of the accessory drive belt Generator ..

Ford Explorer 2020-2026 Service Manual: General Procedures - Driveshaft Angle Measurement

Check NOTE: Prior to checking driveline angularity, inspect the U-joints for correct operation. NOTE: An incorrect driveline angle can cause a vibration or shudder. NOTE: Driveline angularity is the angular relationship between the engine crankshaft, the driveshaft and the rear axle pinion...