Ford Explorer: Climate Control System - General Information / Removal and Installation - Ambient Air Temperature Sensor

Ford Explorer 2020-2026 Service Manual / Electrical / Climate Control System / Climate Control System - General Information / Removal and Installation - Ambient Air Temperature Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the front bumper cover.
    Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
  1. Disconnect the electrical connector. Detach and remove the ambient air temperature sensor.

Installation

  1. To install, reverse the removal procedure.
    • If replacing the ambient air temperature sensor a reset must be performed. Select the A/C and Recirc buttons simultaneously for 5 seconds, then release both, within 2 seconds select A/C button again.

    Removal and Installation - Air Inlet Door Actuator

    Removal Remove the climate control housing. Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...

    Removal and Installation - Blower Motor Control Module

    Removal Remove the push pins and the passenger side insulation panel. Disconnect the electrical connector. Remove the screws and the blower motor ..

    Other information:

    Ford Explorer 2020-2026 Service Manual: Diagnosis and Testing - Locks, Latches and Entry Systems


    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   Diagnostic Trouble Code Chart Module   DTC Description Action   BCM B108F:2..

    Ford Explorer 2020-2026 Service Manual: General Procedures - Roof Opening Panel Alignment


    Adjustment NOTE: Rear Fixed Glass Panel NOTE: If both glass panels are being aligned, align the rear fixed glass panel before aligning the front sliding glass panel. The front sliding glass panel initialization procedure must be done when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel ..

    Categories

    Intelligent Access Key

    Note: You may not be able to shift out of park (P) unless the intelligent access key is inside your vehicle.

    read more

     
    Copyright © 2026 www.foexplorer.com