Ford Explorer: Body Closures / Removal and Installation - Fuel Filler Door Spring
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the fuel filler door assembly.
Refer to: Fuel Filler Door Assembly (501-03 Body Closures, Removal and Installation).
-
Remove the fuel filler door spring.
-
Press the tab upwards to release the fuel filler door spring from the fuel filler door assembly.
-
Pull and remove the fuel filler door spring.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Knife
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
Electronic Leak Detector
Inspection
NOTE:
Use a Rotunda-approved Electronic Leak Detector for R-1234yf refrigerant SAE Certified to J2913.
NOTE:
Good ventilation is necessary in the area where electronic A/C
leak testing is to be carried out...
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Interior Trim Remover
Removal
All vehicles
Fully extend and lower the steering column.
Release the upper gap hider from the IPC and position aside...
Categories
Push the lever up or down to operate
the windshield wipers.

A - Single wipe.
read more