Ford Explorer: Battery and Charging System / High Voltage Battery, Mounting and Cables

Ford Explorer 2020-2022 Service Manual / Electrical / Battery and Charging System / High Voltage Battery, Mounting and Cables

Removal and Installation - Starter Generator - 3.3L Duratec-V6 – Hybrid (BP)

Special Tool(s) / General Equipment Torx Bit Socket Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on..

Description and Operation - High Voltage Battery, Mounting and Cables - Component Location

..

Other information:

Ford Explorer 2020-2022 Service Manual: General Procedures - Valve Guide Inner Diameter


Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Valve guides tend to wear in an hourglass pattern. The ball gauge can be inserted into the combustion chamber side of the valve guide, if necessary. Use a ball gauge to determine the inside diameter of the valve guides in 2 directions at the top, middle and bottom of the valve guide...

Ford Explorer 2020-2022 Service Manual: General Procedures - Cylinder Block Distortion


Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent...

Categories

Fastening the Seatbelts

The front outboard and rear safety restraints in the vehicle are combination lap and shoulder belts.

read more

 
Copyright © 2022 www.foexplorer.com