Ford Explorer: Multifunction Electronic Modules / General Procedures - Factory Mode Deactivation

Ford Explorer 2020-2026 Service Manual / Electrical / Electronic Feature Group / Multifunction Electronic Modules / General Procedures - Factory Mode Deactivation

Deactivation

NOTE: During vehicle build, some modules, such as the IPC and BCM module are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center. If the vehicle is in factory mode, the system automatically reverts to Transport mode after 60 ignition cycles. If the IPC displays TRANSPORT MODE CONTACT DEALER, refer to the Transport Mode Deactivation procedure in this section.

Place the ignition in the OFF position.

Verify the battery is fully charged.
Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures).

Without push button start, cycle the ignition from off to on 60 times.

NOTE: One IKT must be in the vehicle.
With push button start, press the Engine Start/Stop button 120 times.

Refer to the Transport Mode Deactivation procedure in this section.
Refer to: Transport Mode Deactivation (419-10 Multifunction Electronic Modules, General Procedures).

Diagnosis and Testing - Body Control Module C (BCMC)

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..

General Procedures - Transport Mode Deactivation

Deactivation NOTE: After vehicle build, some vehicle modules are set in Transport mode including the IPC and the BCM. Transport mode reduces battery drain during longer periods where the vehicle is..

Other information:

Ford Explorer 2020-2026 Owners Manual: 360 Degree Camera (If Equipped)

WARNING: The 360 degree camera system still requires the driver to use it in conjunction with looking out of the windows, and checking the interior and exterior mirrors for maximum coverage. WARNING: Objects that are close to either corner of the bumper or under the bumper, might not be seen on the screen due to the limited coverage of the camera system...

Ford Explorer 2020-2026 Owners Manual: Switching Adaptive Cruise Control On and Off

The cruise controls are on the steering wheel. See Cruise Control. Switching Adaptive Cruise Control On Press to set the system in standby mode. The indicator, current gap setting and set speed appear in the information display. Switching Adaptive Cruise Control Off Press when the system is in standby mode, or switch the ignition off...