Ford Explorer: Rear Climate Control / Removal and Installation - Rear Evaporator
Removal
NOTE:
The rear evaporator is available only as part of the rear climate control housing.
-
Remove the rear climate control housing.
Refer to: Rear Climate Control Housing (412-02 Rear Climate Control, Removal and Installation).
Installation
-
Transfer the components from the old housing to the new housing as required.
-
To install, reverse the removal procedure.
Removal
NOTICE:
During the removal or installation of components, cap, tape
or otherwise appropriately protect all openings and tubes/fittings to
prevent the ingress of dirt or other contaminati..
Removal
All vehicles
NOTICE:
During the removal or installation of components, cap,
tape or otherwise appropriately protect all openings and tubes/fittings
to prevent the ingress of dirt or o..
Other information:
Inspection
NOTE:
Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur.
Clean and inspect the (1) ring lands, (2) pin bosses,
(3) skirts and the (4) tops of the pistons. If wear marks, scores or
glazing is found on the piston skirt, check for a bent or twisted
connecting rod...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH is similar.
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Categories
4 Inch Display

A - Tachometer.
B - Information display.
C - Speedometer.
D - Fuel gauge.
E - Engine coolant temperature gauge.
read more