Ford Explorer: Climate Control System - General Information / Removal and Installation - Evaporator Temperature Sensor
Removal
-
NOTE:
The evaporator temperature sensor is available only as part of the evaporator.
Remove the evaporator.
Refer to: Evaporator (412-00 Climate Control System - General Information, Removal and Installation).
Installation
-
Transfer the components from the old housing to the new housing as needed.
-
To install, reverse the removal procedure.
Removal
NOTICE:
Use extreme care when releasing the tabs on the climate control housing, or the tabs can be easily damaged.
NOTE:
Removal steps in this procedure may contain installation detai..
Removal
NOTE:
If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.
Remove the climate control housing...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the clips and remove the trim panel.
Remove the bolts, release the clips and remove the display...
Overview
The front subframe is bolted to the body and is used to:
aid in structural support.
provide mounting surfaces for the steering gear.
provide mounting surfaces for the front suspension lower
control arms, the engine mounts and for the front stabilizer bar...
Categories
The front outboard and rear safety restraints in the vehicle are combination
lap and shoulder belts.

read more