Ford Explorer: Intake Air Distribution and Filtering - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Air Cleaner Intake Pipe
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front bumper.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Remove the Intake air venturi.
Torque:
33 lb.in (3.7 Nm)
-
Release the clip and remove the air intake pipe.
-
Dislodge and relocate the air cleaner intake pipe.
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles. When removing any turbocharger or engine air intake
system component, ensure that no debris enter..
Other information:
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during reduced visibility.
You can switch the front fog lamps on if any of the following occur:
You set the lighting control to the parking lamps position.
You set the lighting control to the headlamps position...
A - Battery. See Changing the 12V Battery.
B - Engine oil filler cap. See Engine Oil Check.
C - Engine oil dipstick. See Engine Oil Dipstick.
D - Brake fluid reservoir. See Brake Fluid Check.
E - Engine compartment fuse box. See Fuses.
F - Engine coolant reservoir cap...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more