Ford Explorer: Electrical Distribution / Module Configuration

Removal and Installation - Gateway Module A (GWM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the s..

Description and Operation - Module Configuration - System Operation and Component Description

System Operation Programmable Module Installation (PMI) PMI is a diagnostic scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloade..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Drive Pinion Seal

Special Tool(s) / General Equipment 205-1065Installer, Pinion Seal 205-199 (T83T-3132-A1) Installer, Spindle/Axle ShaftT83-4000-ATKIT-1983-FTKIT-1983-FLMTKIT-1983-FX Flat Headed Screw Driver Materials Name Specification Motorcraft® High Temperature 4x4 Front Axle and Wheel Bearing GreaseXG-11 WSS-M1C267-A1  Removal Remove the front drivesha..

Ford Explorer 2020-2026 Service Manual: General Procedures - Finish Panel Repair

Repair NOTE: Mouldings located on the front and rear window frames may experience minor scratches from vehicle shipment or car wash racks. The imperfections may be repaired instead of replacing components by following the steps below. NOTE: Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced...