Ford Explorer: Battery and Charging System / Generator and Regulator

Removal and Installation - Generator Current Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the battery/batteries. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and ..

Specifications

  General Specifications Item Specification 2.3L EcoBoost - Limited and XLT with trailer tow vehicles built before October 2020 Rating ..

Other information:

Ford Explorer 2020-2026 Service Manual: General Procedures - Bezel Diagnostics

Check NOTE: If there is a concern with one of the following components and Bezel Diagnostics cannot be accessed, obtain the module part number by referencing the label attached to the module. Inoperative ACM Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display) Inoperative FCIM or radio control panel Inoperative steering w..

Ford Explorer 2020-2026 Service Manual: General Procedures - Module Programming

Check NOTE: Perform the following pre-checks to make sure module programming completes without errors. Start the programming session in KOEO. Make sure the vehicle battery is fully charged or is connected to a battery charger. The battery state of charge should be 12...