Ford Explorer: Climate Control System - General Information / Description and Operation - Climate Control System - Overview
Vehicles with: Dual Automatic Temperature Control (DATC)
Overview
The DATC system maintains the selected vehicle interior temperature by heating and/or cooling the air depending on the HVAC control panel selection.
-
The driver may override the automatic mode of operation.
-
The temperature control setting is the desired cabin air temperature.
-
The blower motor control override buttons vary the blower motor speed.
-
The driver side and passenger side temperature settings can be individually controlled.
-
During A/C operation, the system reduces the relative humidity of the air inside the vehicle.
For the HEV equipped with supplemental heating.
Refer to: Supplemental Climate Control - System Operation and Component Description (412-03 Supplemental Climate Control, Description and Operation).
.
System Operation
System Diagram
Item
Description
1
Hybrid
2
FDIM
3
Microphone
4
APIM
5
GWM
6
A/C clutch relay
7
Sunload sensor
8
FC..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the sunload sensor from the instrument panel.
Disconnect the electrical connector.
Use the General Equipment: Interior Trim Remover
Installation
To install, reverse the removal procedure...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
DSM
B12A7:1..
Categories
You can use the power door lock control or the remote control to lock and unlock
your vehicle.
Power Door Locks
The power door lock control is on the driver and front passenger door panels.

read more