Ford Explorer: Remote Control / Sounding the Panic Alarm
Note: The panic alarm only operates when the ignition is off.
Press the button to sound the panic
alarm. Press the button again or switch the ignition on to turn it off.
Press the button twice within three
seconds. The horn sounds and the direction indicators flash. We recommend you use
this method to locate your vehicle, rather than using the panic alarm...
WARNING: To avoid exhaust fumes, do not use remote start if your vehicle
is parked indoors or in areas that are not well ventilated.
Note: Do not use remote start if your fuel level is low...
Other information:
Removal
NOTE:
If installing a new PAM,
it is necessary to upload the module configuration information to the
scan tool prior to removing the module. This information must be
downloaded into the new PAM after installation.
Using a diagnostic scan tool, begin the PMI process for the PAM following the onscreen instructions...
System Operation
System Diagram
Item
Description
1
Clockspring
2
Horn Switch
3
SCCM
4
BCM
5
BCMC
6
Horn
Horn Operation
The horn switch uses sets of contacts separated by springs...
Categories
Push the lever up or down to operate
the windshield wipers.

A - Single wipe.
read more