Ford Explorer: Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Turbocharger Bypass Valve

Ford Explorer 2020-2026 Service Manual / Powertrain / Engine / Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Turbocharger Bypass Valve

Removal

NOTE: Removal steps in this procedure may contain installation details.

Disconnect the electrical connector and harness retainers.

Remove the bolts and the turbocharger bypass valve.
Torque: 53 lb.in (6 Nm)

Installation

To install, reverse the removal procedure.

Removal and Installation - Boost Pressure Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the LH headlamp assembly. Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Insta..

Removal and Installation - Variable Camshaft Timing (VCT) Oil Control Solenoid

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the valve cover. Refer to: Valve Cover (303-01A Engine - 2...

Other information:

Ford Explorer 2020-2026 Service Manual: Specifications

Materials Name Specification Motorcraft® SAE 75W-140 Synthetic Rear Axle Lubricant / XY-75W140-QL WSL-M2C192-A Motorcraft® High Temperature 4x4 Front Axle and Wheel Bearing Grease XG-11 WSS-M1C267-A1 Capacities Item Liters Material: Motorcraft® SAE 75W-140 S..

Ford Explorer 2020-2026 Service Manual: General Procedures - Piston Inspection

Inspection NOTE: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur. Clean and inspect the (1) ring lands, (2) pin bosses, (3) skirts and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod...