Ford Explorer: Wipers and Washers / Removal and Installation - Rain Sensor

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Wipers and Washers / Removal and Installation - Rain Sensor

Materials

Name	Specification
Motorcraft® Ultra-Clear Spray Glass Cleaner ZC-23	ESR-M14P5-A

Removal

Remove the interior rear view mirror.
Refer to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation).

Remove the rain sensor.
1. Disconnect the rain sensor electrical connector and position the harness aside.
1. On both sides.
  Release the retainers.
1. Remove the rain sensor.

Installation

Clean the windshield glass area of foreign materials.
Material: Motorcraft® Ultra-Clear Spray Glass Cleaner / ZC-23 (ESR-M14P5-A)

NOTE: If the rain sensor gel pack is damaged, install a new rain sensor.
Inspect the rain sensor gel pack for damage.

Install the rain sensor and connect the electrical connector.

Install the interior rear view mirror.
Refer to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation).

Removal and Installation - Front Parking Aid Camera Washer Jet

Removal Remove the front parking aid camera. Refer to: Front Parking Aid Camera (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Removal and Installation)...

Removal and Installation - Rear Parking Aid Camera Washer Jet

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear parking aid camera. Refer to: Rear Parking Aid Camera (413-13B Parking Aid - Vehicles Wit..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Accessory Drive Belt

Removal NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys...

Ford Explorer 2020-2026 Service Manual: Disassembly - Engine

Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 303-050 (T70P-6000) Lifting Bracket, Engine 303-1685Alignment Tool, Camshaft 303-1687Installer, VCT Solenoid Seal 303-1689Holding Tool, Crank Damper 303-409 (T92C-6700-CH) Remover, Crankshaft SealTKIT-1992-FH/FMH/FLMHTKIT-1993-LMH/MH 303-507Timing Peg, Crankshaft TDCTKIT-2001N-FL..