Ford Explorer: Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Powertrain Control Module (PCM)

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: This step is only necessary when installing a new component.

   Download the module information to the diagnostic tool using the Programmable Modules Installation routine.
   Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).
   Use the General Equipment: Ford Diagnostic Equipment

1. Disconnect the electrical connectors. Remove the bolts and the PCM.
   Torque: 97 lb.in (11 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   Upload the module information from the diagnostic tool using the Programmable Modules Installation routine.
   Refer to: Module Programming (418-01 Module Configuration, General Procedures).
   Use the General Equipment: Ford Diagnostic Equipment

1. NOTE: This step is only necessary when installing a new component.

   Reprogram the Passive Anti-Theft System (PATS) .
   Refer to: Anti-Theft Key Programming - Scan Tool (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Keyless Vehicle System, General Procedures).
   

1. NOTE: This step is only necessary when installing a new component.

   Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.