Ford Explorer: Police Equipment / Removal and Installation - Liftgate Flashing Light Emitting Diode (LED) Lamps
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH is similar.
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the nuts and the liftgate flashing LED lamp.
Torque:
19 lb.in (2.2 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH is similar.
Remove the screws and the trim cover...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Main lighting and siren module
Remove the bolts and the loadspace floor panel...
Other information:
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Knife
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The fuel filler door assembly is damaged during the removal
process and requires a new fuel filler door assembly installed...
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Using a diagnostic scan tool, begin the PMI process for the WACM following the on-screen instructions...
Categories
Push the lever up or down to operate
the windshield wipers.

A - Single wipe.
read more