Kia Picanto: Steering Wheel and Column Electrical Components / Removal and Installation - Ignition Lock Cylinder Housing
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the clips and remove the instrument panel upper finish panel and the ignition lock cylinder housing.
-
Disconnect the electrical connectors.
-
Remove the retainers and the shift interlock solenoid.
-
Remove the retainers and remove the ignition lock cylinder housing assembly.
Installation
-
To install, reverse the removal procedure.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Informati..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the ignition lock cylinder housing.
Refer to: Ignition Lock Cylinder Housing (211-05 Steering Whee..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column upper shaft.
Refer to: Steering Column Upper Shaft (211-04 Steering Column, Removal and Installation).
Remove the cowl panel...
Driver’s seat belt warning
Each time the ignition switch or ENGINE START/STOP button is switched ON, the
driver’s seat belt warning light illuminates for approximately six seconds, whether or not the belt is fastened. If
the belt is unfastened, an accompanying chime sounds for approximately six seconds...
Categories
4 Inch Display

A - Tachometer.
B - Information display.
C - Speedometer.
D - Fuel gauge.
E - Engine coolant temperature gauge.
read more