Ford Explorer: Steering Wheel and Column Electrical Components / Removal and Installation - Ignition Switch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the ignition lock cylinder housing.
Refer to: Ignition Lock Cylinder Housing (211-05 Steering Wheel and Column Electrical Components, Removal and Installation).
-
Release the tabs and remove the ignition switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the clips and remove the instrument panel upper finish panel and the ignition lock cylinder hous..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the clips and remove the trim panel.
Remove the retainers...
Other information:
Summer tires provide superior performance on wet and dry roads. Summer tires
do not have the Mud and Snow (M+S or M/S) tire traction rating on the tire side
wall. Since summer tires do not have the same traction performance as All-season
or Snow tires, we do not recommend using summer tires when temperatures drop to
approximately 45°F (7°C) or below (depending on tire wear and environmen..
Removal
NOTE:
It is not necessary to remove the transmission fluid
filter to remove the transmission fluid auxiliary pump.
Remove the transmission fluid pan and gasket.
Refer to: Transmission Fluid Pan, Gasket and Filter (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation)...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more