Ford Explorer: Front End Body Panels / Removal and Installation - Engine Front Undershield
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting)
.
-
Remove the bolts and the push pin.
Torque:
22 lb.in (2.5 Nm)
-
Remove the bolts and the engine front undershield.
Torque:
22 lb.in (2.5 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wiper pivot arms.
Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal a..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the Engine front undershield.
Refer to: Engine Front Undershield (501-02 Front End Body Panels, Re..
Other information:
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully. Failure to follow step instructions may
result in incorrect operation of the restraint system and increases the
risk of serious personal injury or death in a crash...
Removal
Remove the driver side knee airbag.
Refer to: Driver Knee Airbag (501-20B Supplemental Restraint System, Removal and Installation).
Disconnect the electrical connector and remove the driver side footwell air discharge temperature sensor...
Categories
Push the lever up or down to operate
the windshield wipers.

A - Single wipe.
read more