Ford Explorer: Multifunction Electronic Modules / Removal and Installation - Driver Door Module (DDM)

Ford Explorer 2020-2026 Service Manual / Electrical / Electronic Feature Group / Multifunction Electronic Modules / Removal and Installation - Driver Door Module (DDM)

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation.
Carry out the PMI procedure for the DDM.
Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).

Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

Remove the bolts and the DDM.
- Disconnect the elecrical connectors.

Installation

Using the previous diagnostic scan tool session, carry out the PMI procedure for the DDM.
Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).

If installing a new module, carry out the power door window initialization on the drivers side front door and rear door windows.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

Removal and Installation - Body Control Module C (BCMC)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If the BCMC did not respond to the diagnostic scan tool, As-Built Data may need to be entered as p..

Removal and Installation - Passenger Door Module (PDM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the d..

Other information:

Ford Explorer 2020-2026 Service Manual: Diagnosis and Testing - Body Control Module (BCM)

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Diagnostic Trouble Code Chart Module DTC Description Action BCM B11D9:1..

Ford Explorer 2020-2026 Owners Manual: USING DRIVER ALERT

Switching the System On and Off Switch the system on or off using the touchscreen. See Settings. When active, the system monitors your alertness level based upon your driving behavior in relation to the lane markings, and other factors. System Warnings Note: The system does not issue warnings below approximately 40 mph (64 km/h)...