Ford Explorer: Front Disc Brake / Removal and Installation - Brake Caliper Anchor Plate
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-03 Front Disc Brake, Removal and Installation).
-
Remove the bolts and the anchor plate. Discard the bolts
Torque:
129 lb.ft (175 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
Service actions on vehicles equipped with electronic brake
booster and electronic parking brakes may cause unexpected brake
application, which could result in injury to ..
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B
-
Removal
WARNING:
Service actions on vehicles equipped with electronic brake
..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the wedge nut.
NOTE:
Typical application shown.
Loosen the wedge screw 6 turns.
Torque:
62 lb.in (7 Nm)
Press the wedge screw inward to release the wedge nut...
Special Tool(s) /
General Equipment
Hot Air Gun
DISASSEMBLY
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
Disconnect the front bumper cover wiring harness connectors...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more