Ford Explorer: Chassis / Brake System
Ford Explorer 2020-2026 Service Manual / Chassis / Brake System
- Brake System - General Information
- Front Disc Brake
- Rear Disc Brake
- Parking Brake and Actuation
- Hydraulic Brake Actuation
- Power Brake Actuation
- Anti-Lock Brake System (ABS) and Stability Control
Removal and Installation - Rear Halfshaft
Removal
NOTICE:
Never pick up or hold the halfshaft by only the inner or outer CV joint. Damage to the CV joint will occur.
NOTICE:
Never use a hammer to remove or install the halfshafts...
Other information:
Ford Explorer 2020-2026 Service Manual: Removal and Installation - Sunload Sensor
Special Tool(s) / General Equipment Interior Trim Remover Removal Remove the sunload sensor from the instrument panel. Disconnect the electrical connector. Use the General Equipment: Interior Trim Remover Installation To install, reverse the removal procedure...
Ford Explorer 2020-2026 Service Manual: Removal and Installation - Air Cleaner Intake Pipe
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). Remove the Intake air venturi. Torque: 33 lb...
Categories
- Manuals Home
- 6th Generation Explorer Owners Manual
- 6th Generation Explorer Service Manual
- General Procedures - Rear Camber Adjustment
- General Procedures - Brake Service Mode Activation and Deactivation
- Driveline
- New on site
- Most important about car
Seatbelt Height Adjustment
WARNING: Position the seatbelt height adjuster so that the seatbelt rests across the middle of your shoulder. Failure to adjust the seatbelt correctly could reduce its effectiveness and increase the risk of injury in a crash.
Copyright © 2026 www.foexplorer.com