Ford Explorer: Information and Entertainment System - General Information - Vehicles Without: SYNC 3 / Removal and Installation - AM/FM1 Antenna Amplifier
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the clips and remove the liftgate center upper trim panel.
Use the General Equipment: Interior Trim Remover
-
Disconnect the connectors, remove the screw and the AM/FM1 antenna amplifier.
Torque:
93 lb.in (10.5 Nm)
Installation
-
To install, reverse the removal procedure.
Activation
NOTE:
The procedure used to download the audio files varies, depending on the web browser used.
Using a suitable web browser, download all of the diagnostic sound tracks to a su..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during reduced visibility.
You can switch the front fog lamps on if any of the following occur:
You set the lighting control to the parking lamps position.
You set the lighting control to the headlamps position...
Adaptive cruise control limitations apply to lane centering unless stated otherwise
or contradicted by a lane centering limitation. See Adaptive Cruise Control Limitations.
The system may not correctly operate in any of the following conditions:
Your vehicle is not centered in the lane...
Categories
The front outboard and rear safety restraints in the vehicle are combination
lap and shoulder belts.

read more