Ford Explorer: Electrical Distribution / Module Communications Network
Overview
Multiplexing
is a method of sending 2 or more signals simultaneously over a single
circuit. Multiplexing allows 2 or more electronic modules (nodes) to
communicate over a twisted wire pai..
Other information:
Deactivation
NOTE:
During vehicle build, some modules, such as the IPC and BCM module are set in factory mode.
Factory mode reduces the drain on the battery during longer periods
where the vehicle is not used. While in the factory mode, various
systems may be altered or disabled and the IPC
displays FACTORY MODE CONTACT DEALER in the message center...
Autolock locks all the doors when
All doors close.
The ignition is on.
You shift into any gear putting your vehicle in motion.
Your vehicle reaches a speed greater than 12 mph (20 km/h)
Autolock repeats when
You open then close any door while the ignition is on and your vehicle speed
is 9 mph (15 km/h) or lower...
Categories
WARNING: Do not place your arms on the airbag cover or through the steering
wheel. Failure to follow this instruction could result in personal injury.
WARNING: Keep the areas in front of the airbags free from obstruction.
Do not affix anything to or over the airbag covers. Objects could become projectiles
during airbag deployment or in a sudden stop. Failure to follow this instruction
could result in personal injury or death.
WARNING: Airbags can kill or injure a child in a child restraint. Never
place a rear-facing child restraint in front of an active airbag. If you must use
a forward-facing child restraint in the front seat, move the seat upon which the
child restraint is installed all the way back.

read more