Ford Explorer: Locking and Unlocking / Illuminated Entry & Illuminated Exit

Ford Explorer 2020-2022 Owners Manual / Doors and Locks / Locking and Unlocking / Illuminated Entry & Illuminated Exit

Illuminated Entry

The interior lamps and some exterior lamps illuminate when you unlock the doors with the remote control.

The lamps turn off if:

  • The ignition is on.
  • You press the remote control lock button.
  • 25 seconds have elapsed.

The lamps do not turn off if:

  • You switch them on with the lighting control.
  • Any door is open.

Illuminated Exit

The interior lamps and some exterior lamps illuminate when all doors close and you switch the ignition off.

The lamps turn off if all the doors remain closed and:

  • 25 seconds have elapsed.
  • You lock your vehicle from the outside.

Battery Saver

If you leave the courtesy lamps, interior lamps or headlamps on, the battery saver shuts them off 10 minutes after you switch the ignition off.

Battery Saver for Intelligent Access Keys (If Equipped)

If you leave the ignition switched on and the engine is not running, the battery saver turns the ignition off when it detects a certain amount of battery drain, or after 45 minutes have elapsed.

    Autolock (If Equipped

    Autolock locks all the doors when All doors close. The ignition is on. You shift into any gear putting your vehicle in motion. Your vehicle reaches a speed greater than 12 mph (20 km/h) A..

    Keyless Entry

    SECURICODEā„¢ Keyless Entry Keypad The keypad is near the driver window. It illuminates when touched. Note: If you enter your entry code too fast on the keypad, the unlock function may not work...

    Other information:

    Ford Explorer 2020-2022 Service Manual: Removal and Installation - Driver Side Register Air Discharge Temperature Sensor


    Removal Remove the IPC. Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation). Disconnect the electrical connector and remove the driver side register air discharge temperature sensor...

    Ford Explorer 2020-2022 Service Manual: Removal and Installation - Powertrain Control Module (PCM)


    Special Tool(s) / General Equipment Ford Diagnostic Equipment Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component. Download the module information to the diagnostic tool using the Programmable Modules Installation routine...

    Categories

    Integrated Keyhead Transmitter (If Equipped)

    Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle. The integrated keyhead transmitter functions as a programmed ignition key that operates all the locks and starts your vehicle, as well as a remote control.

    read more

     
    Copyright Ā© 2022 www.foexplorer.com