Ford Explorer: Maintenance / Changing the Rear Wiper Blades
You can improve poor wiper quality by cleaning the wiper blades and the windshield.
Replace the wiper blades at least annually for optimum performance.

- Lift the wiper arm.
Note: Do not hold the wiper blade to lift the
wiper arm.
- Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the wiper blade is not attached.
- To install, reverse the removal procedure.
Note: Make sure that
the wiper blade locks into place.
Run the tip of your fingers over the edge of the blade to check for roughness.
Clean the wiper blades with washer fluid or water applied with a soft sponge
or cloth...
Vertical Aim Adjustment
If your vehicle has been involved in a crash, have the aim of the headlamp beam
checked by an authorized dealer.
A - 8 ft (2...
Other information:
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all openings to prevent the ingress of dirt or
other contamination. Remove protective materials prior to installation.
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the ignition coil-on-plugs.
Refer to: Ignition Coil-On-Plug (303-07A Engine Ignition - 2.3L EcoBoost (201kW/273PS), Removal and Installation).
Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs...
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more