Ford Explorer: Wipers and Washers / Removal and Installation - Windshield Wiper Pivot Arm
Special Tool(s) /
General Equipment
Removal
NOTE:
RH shown, LH similar.
-
Remove windshield wiper pivot arm nut cover.
-
Remove windshield wiper pivot arm nut.
-
Remove the wiper pivot arm.
Use the General Equipment: Two Leg Puller
Installation
-
Verify the windshield wiper motor is in the PARK position.
-
Turn the ignition ON.
-
Pull the switch down to cycle the windshield wiper motor.
-
Turn the ignition OFF.
-
NOTE:
The hood is removed in this step for clarity.
Install the wiper pivot arm.
-
Align the wiper blade with the marks on the windshield.
-
Install the wiper pivot arm nut.
Torque:
22 lb.ft (30 Nm)
-
Install the windshield wiper pivot arm nut cover.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wiper linkage assembly.
Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal a..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The hood is removed in this procedure for clarity.
Remove the cowl panel grille...
Other information:
WARNING: Sitting improperly, out of position or with the seatback reclined
too far can take weight off the seat cushion and affect the decision of the passenger
sensing system, resulting in serious injury or death in the event of a crash. Always
sit upright against your seat back, with your feet on the floor...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the liftgate latch bolts...
Categories
4 Inch Display

A - Tachometer.
B - Information display.
C - Speedometer.
D - Fuel gauge.
E - Engine coolant temperature gauge.
read more