Ford Explorer: Tire Pressure Monitoring System (TPMS) / Removal and Installation - Tire Pressure Monitoring System (TPMS) Sensor

Ford Explorer 2020-2025 Service Manual / Chassis / Suspension / Tire Pressure Monitoring System (TPMS) / Removal and Installation - Tire Pressure Monitoring System (TPMS) Sensor

Removal

  1.   WARNING: The Tire Pressure Monitoring System (TPMS) sensor battery may release hazardous chemicals if exposed to extreme mechanical damage. If these chemicals contact the skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If any part of the battery is swallowed, contact a physician immediately. When disposing of Tire Pressure Monitoring System (TPMS) sensors, follow the correct procedures for hazardous material disposal. Failure to follow these instructions may result in serious personal injury.

    IPTV Free Trial

    NOTE: The Tire Pressure Monitoring System (TPMS) sensor cannot be removed without disassembly of the wheel and tire.

    Disassemble the wheel and tire.

Installation

  1. NOTE: The Tire Pressure Monitoring System (TPMS) sensor cannot be installed without disassembly of the wheel and tire.

    Assemble the wheel and tire.

    General Procedures - Tire Pressure Monitoring System (TPMS) Sensor Location Calibration

    Special Tool(s) / General Equipment 204-D081A (204-D081) Tire Pressure Monitor (TPMS) Ford Diagnostic Equipment Programming NOTE: The TPMS can be placed into learn mode using a ..

    Driveline

    ..

    Other information:

    Ford Explorer 2020-2025 Service Manual: General Procedures - Transmission Line Pressure Test


    Materials Name Specification Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV WSS-M2C949-A, MERCON® ULV  Check With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

    Ford Explorer 2020-2025 Service Manual: General Procedures - Bezel Diagnostics


    Check NOTE: If there is a concern with one of the following components and Bezel Diagnostics cannot be accessed, obtain the module part number by referencing the label attached to the module. Inoperative ACM Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display) Inoperative FCIM or radio control panel Inoperative steering w..

    Categories

    Integrated Keyhead Transmitter (If Equipped)

    Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle. The integrated keyhead transmitter functions as a programmed ignition key that operates all the locks and starts your vehicle, as well as a remote control.

    read more

     
    Copyright © 2025 www.foexplorer.com