Kia Picanto: Steering Column / Removal and Installation - Steering Column Tilt Motor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the steering column.
Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
-
NOTE:
Note the position of the component before removal.
Remove the tilt motor.
-
Remove the trunnion bracket retainers and bracket.
-
Remove the tilt motor retainers and remove the tilt motor.
Installation
-
On both sides.
Apply grease (supplied with the new motor) to the
trunnion nut axles and the tilt motor lead-screw housing holes.
-
Rotate the trunnion nut until the correct length is
achieved to align the lead-screw housing with the threaded holes in the
support arm.
-
Install the tilt motor.
-
Position the tilt motor and install the tilt motor retainers.
Torque:
124 lb.in (14 Nm)
-
Install the trunnion bracket and the trunnion bracket retainers.
Torque:
71 lb.in (8 Nm)
-
Install the steering column.
Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
-
If equipped with memory steering column, use the
steering column control switch and set the tilt motor soft stops as
follows.
-
Move the column upward until it reaches the end of travel.
-
Move the column in the same direction until it reaches the end of travel again.
-
Move the column downward until it reaches the end of travel.
-
Move the column in the same direction until it reaches the end of travel again.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column.
Refer to: Steering Column (211-04 Steering Column, Removal and Installation)...
Special Tool(s) /
General Equipment
Adhesive Tape
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Make sure the wheels and steering wheel is ..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Driver seat shown, passenger seat similar.
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
Release the front seat backrest panel straps...
Special Tool(s) /
General Equipment
303-1567Sizer, Teflon SealTKIT-2010C-FLM
307-005
(T59L-100-B)
Slide Hammer
310-205Fuel Injector Brush
310-206Remover, Fuel InjectorTKIT-2009A-FLM
310-207Installer, Fuel Injector Seal AssemblyTKIT-2009A-FLM
Removal
NOTICE:
Fuel injection equipment is manufactured to very precise
tolerances and fine clearances...
Categories
WARNING: Do not place your arms on the airbag cover or through the steering
wheel. Failure to follow this instruction could result in personal injury.
WARNING: Keep the areas in front of the airbags free from obstruction.
Do not affix anything to or over the airbag covers. Objects could become projectiles
during airbag deployment or in a sudden stop. Failure to follow this instruction
could result in personal injury or death.
WARNING: Airbags can kill or injure a child in a child restraint. Never
place a rear-facing child restraint in front of an active airbag. If you must use
a forward-facing child restraint in the front seat, move the seat upon which the
child restraint is installed all the way back.

read more