Ford Explorer: Second Row Seats / Removal and Installation - Second Row Single Seat Easy Entry Seat Fold Switch
Removal
NOTE:
Removal steps in this procedure may include installation details.
-
Release the retainers and remove the second row single seat easy entry seat fold switch bezel.
-
Remove the second row single seat easy entry seat fold switch.
-
Remove the screws.
Torque:
18 lb.in (2 Nm)
-
Disconnect the electrical.
Installation
-
To install, reverse the removal procedure..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left hand) seat shown, RH (right hand) seat similar.
Remove the second row seat...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool release and position the light sensor.
Use the General Equipment: Interior Trim Remover
Disconnect the electrical connector and remove the light sensor...
Special Tool(s) /
General Equipment
100-001
(T50T-100-A)
Slide Hammer
205-1018Installation Tube
307-309Remover, Torque Converter SealTKIT-1994-FMH/FLMHTKIT-1994-LMH/MHTKIT-1994-FH
307-782Installer, Output Shaft Seal
Punch
Removal
With the vehicle in NEUTRAL, position it on a hoist...
Categories
WARNING: Airbags can kill or injure a child in a child restraint. Never
place a rear-facing child restraint in front of an active airbag. If you must use
a forward-facing child restraint in the front seat, move the seat upon which the
child restraint is installed all the way back.

read more