Ford Explorer: Supplemental Climate Control / Removal and Installation - Rear Evaporator Shutoff Valve
Removal
NOTE:
The rear evaporator shutoff valve is available only as part of the rear evaporator.
-
Remove the rear evaporator.
Refer to: Rear Evaporator (412-02 Rear Climate Control, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Hose Clamp(s)
Hose Clamp Remover/Installer
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all o..
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
NOTE:
New exhaust manifold gaskets, studs, nuts and/or
bolts must be installed when an exhaust manifold is serviced...
If required, have an authorized dealer check and change the transmission fluid
at the correct service interval. See Scheduled Maintenance.
The automatic transmission does not have a transmission fluid dipstick.
Refer to your scheduled maintenance information for scheduled intervals for fluid
checks and changes...
Categories
Use the key blade to start your vehicle and unlock or lock the driver door from
outside your vehicle. The integrated keyhead transmitter functions as a programmed
ignition key that operates all the locks and starts your vehicle, as well as a remote
control.
read more