Kia Picanto: Rear Climate Control / Removal and Installation - Rear Blower Motor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
-
Disconnect the electrical connector.
-
Detach the wire harness clips and position the wire harness aside.
-
Remove the retainers and the rear blower motor.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentatio..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentatio..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Refer to: Roof Opening Panel Fixed Glass (501-17 Roof Opening Panel, Removal and Installation)...
Removal
NOTE:
Typical LH (left-hand) seat shown, RH (right-hand) seat similar.
NOTE:
Removal steps in this procedure may contain installation details.
Raise the seat to the full up position.
Disconnect the electrical connector...
Categories
Note: You may not be able to shift out of park (P) unless the intelligent
access key is inside your vehicle.

read more