Ford Explorer: Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Knock Sensor (KS)

Ford Explorer 2020-2026 Service Manual / Powertrain / Engine / Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS) / Removal and Installation - Knock Sensor (KS)

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the intake manifold.
Refer to: Intake Manifold (303-01 Engine - 2.3L EcoBoost (201kW/273PS)) .

NOTE: Note the position of the components before removal.
Remove the KS.
Torque: 18 lb.ft (25 Nm)

Installation

NOTE: Make sure that the components are installed to the position noted before removal.
To install, reverse the removal procedure.

Removal and Installation - Intake Air Temperature (IAT) Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the IAT electrical connector. Remove the IAT sensor...

Removal and Installation - Manifold Absolute Pressure and Temperature (MAPT) Sensor

Materials Name Specification Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A ESE-M1C171-A Removal NOTE: Removal steps in this procedure may conta..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Brake Pads

Special Tool(s) / General Equipment 12” / 300mm C-Clamp Materials Name Specification Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B - Removal WARNING: Service actions on vehicles equipped with electronic brake booster and electronic parking brakes may cause unexpected brake application, which could result in injury to hands or fingers...

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Ignition Lock Cylinder Housing

Removal NOTE: Removal steps in this procedure may contain installation details. Release the clips and remove the instrument panel upper finish panel and the ignition lock cylinder housing. Disconnect the electrical connectors...