Kia Picanto: Exterior Lighting / Removal and Installation - Headlamp Switch
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Using a non-marring tool, release and position the headlamp switch out.
Use the General Equipment: Interior Trim Remover
-
Disconnect the electrical connector and remove the headlamp switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Front suspension mounted
Remove the LH front wheel and tire assembly...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear spoiler.
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Inst..
Other information:
Special Tool(s) /
General Equipment
303-1567Sizer, Teflon SealTKIT-2010C-FLM
307-005
(T59L-100-B)
Slide Hammer
310-205Fuel Injector Brush
310-206Remover, Fuel InjectorTKIT-2009A-FLM
310-207Installer, Fuel Injector Seal AssemblyTKIT-2009A-FLM
Removal
NOTICE:
Fuel injection equipment is manufactured to very precise
tolerances and fine clearances...
Programming
NOTE:
A passive key with a depleted battery(ies) only starts the vehicle when in the backup starting location. The RKE functionality remains inoperative until the key battery(ies) is replaced.
NOTE:
The diagnostic scan tool must have an active Internet connection...
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more