Ford Explorer: Exterior Lighting / Removal and Installation - Front Fog Lamp

Ford Explorer 2020-2026 Service Manual / Electrical / Lighting / Exterior Lighting / Removal and Installation - Front Fog Lamp

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).

NOTE: LH side shown, RH side similar.
Remove the screws and the foglamp assembly.
Torque: 11 lb.in (1.2 Nm)

Installation

To install, reverse the removal procedure.

Adjust the front fog lamp.
Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting, General Procedures).

General Procedures - Headlamp Adjustment

Adjustment NOTE: If the flash video link does not load or is incompatible with your browser, a .wmv version of the video can be accessed at: http://www...

Removal and Installation - Headlamp Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation)...

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - A-Pillar Moulding

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTICE: Only use moderate force. NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH similar. Using a non-marring trim removal tool disengage the retainer clips starting approximately 9 inches from the top...

Ford Explorer 2020-2026 Service Manual: General Procedures - Fuel System Pressure Release

Pressure release With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). Remove the nuts and bolts. Torque: 55 lb.in (6.2 Nm) Remove the retainers and air deflector...