Ford Explorer: Automatic Transmission External Controls - 10-Speed Automatic Transmission – 10R60 / Removal and Installation - Downshift Paddle Switch

Ford Explorer 2020-2026 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission External Controls - 10-Speed Automatic Transmission – 10R60 / Removal and Installation - Downshift Paddle Switch

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the steering wheel.
Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).

Remove the bolts and the steering wheel rear cover.

On both sides.
Disconnect the electrical connectors.

Remove the bolts and the steering wheel bezel.

Remove the bolt and the downshift paddle switch.

Installation

To install, reverse the removal procedure.

General Procedures - Transmission Park by Wire Manual Release

Activation NOTE: If the vehicle has a discharged battery, an external power source is required. Apply the parking brake. Open the console door ..

Removal and Installation - Gear Shift Module (GSM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Move the front seats forward and rearward as necessary to access floor console components...

Other information:

Ford Explorer 2020-2026 Service Manual: Diagnosis and Testing - Rear View Mirrors

DTC Chart: DDM Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). DTC Description Action B11F6:01 Driver Folding Mirror Motor: General Electrical Failure GO to Pinpoint Test E ..

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Radio Transceiver Module (RTM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation...