Ford Explorer: Body and Paint / Paint - General Information

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Paint - General Information

Removal and Installation - Water Drain Panel

Special Tool(s) / General Equipment Resistance Spotwelding Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specifi..

General Procedures - Paintwork Defects and Damage

Materials Name Specification Motorcraft® Acid NeutralizerZC-1-A -  Motorcraft® Alkaline NeutralizerZC-2-A -  Repair NOTE: Refinishing - Environmental Damage ..

Other information:

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Rear Door Upper Moulding


Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the upper belt moulding screw at front of the door. Torque: 12 lb.in (1.3 Nm) Lift the moulding at the front edge using a non-marring trim tool and slide forward to disengage from the tab at the rear and remove th..

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Ambient Air Temperature Sensor


Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). Disconnect the electrical connector...

Categories

Gauges

4 Inch Display

A - Tachometer.

B - Information display.

C - Speedometer.

D - Fuel gauge.

E - Engine coolant temperature gauge.

read more

 
Copyright © 2026 www.foexplorer.com