Ford Explorer: Wipers and Washers / General Procedures - Washer Hose Repair

Ford Explorer 2020-2026 Service Manual / Body and Paint / Body and Paint / Wipers and Washers / General Procedures - Washer Hose Repair

Repair

NOTE: This procedure may be carried out on rubber hoses only. If a plastic washer hose is damaged, a new washer hose must be installed.

Locate and verify the damaged washer hose.

Cut the hose cleanly and remove the damaged portion of the washer hose.
Dimension: 0.5000 in ( 12.7 mm)

Install a windshield washer hose adapter between the cut ends of the hose.

NOTE: In difficult cases, clamping may be required.
If necessary, install a segment of 6.4 mm (0.25 in) ID black rubber hose over the ends of the washer hose and clamp both ends of the rubber hose using spring clamps.

General Procedures - Washer Hose Coupling

Disconnect WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

Removal and Installation - Front Parking Aid Camera Washer Jet

Removal Remove the front parking aid camera. Refer to: Front Parking Aid Camera (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Removal and Installation)...

Other information:

Ford Explorer 2020-2026 Owners Manual: USING DRIVER ALERT

Switching the System On and Off Switch the system on or off using the touchscreen. See Settings. When active, the system monitors your alertness level based upon your driving behavior in relation to the lane markings, and other factors. System Warnings Note: The system does not issue warnings below approximately 40 mph (64 km/h)...

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Second Row Seat Climate Control Module

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: The SCMF (second row seat climate control module) is located under the RH (right-hand) second row seat cushion frame. NOTE: This step is only necessary when installing a new component...