Ford Explorer: Engine System - General Information / General Procedures - Piston Diameter
Check
-
-
Measure the piston diameter 90 degrees from the
piston pin and piston diameter (DN) height down from the top of the
piston at the point indicated.
-
Refer to specifications for the piston diameter (DN) height.
Refer to: Specifications (303-01A Engine - 2.3L EcoBoost (201kW/273PS), Specifications).
Refer to: Specifications (303-01B Engine - 3.0L EcoBoost, Specifications).
Refer to: Specifications (303-01C Engine - 3.3L Duratec-V6, Specifications).
Refer to: Specifications (303-01D Engine - 3.3L Duratec-V6 – Hybrid (BP), Specifications).
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces...
Inspection
NOTE:
Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur.
Clean and inspect the (1) ring lands, (2) pin bosses,
(3) skirts and th..
Other information:
WARNING: Use a floor mat designed to fit the footwell of your vehicle that
does not obstruct the pedal area. Failure to follow this instruction could result
in the loss of control of your vehicle, personal injury or death.
WARNING: Pedals that cannot move freely can cause loss of vehicle control
and increase the risk of serious personal injury...
Removal
NOTE:
It is not necessary to remove the transmission fluid
filter to remove the transmission fluid auxiliary pump.
Remove the transmission fluid pan and gasket.
Refer to: Transmission Fluid Pan, Gasket and Filter (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation)...
Categories
WARNING: Position the seatbelt height adjuster so that the seatbelt rests
across the middle of your shoulder. Failure to adjust the seatbelt correctly could
reduce its effectiveness and increase the risk of injury in a crash.

read more