Ford Explorer: Electrical / Electronic Feature Group
Check
NOTE:
Perform the following pre-checks to make sure module programming completes without errors.
Start the programming session in KOEO...
Other information:
Removal
Release the clips and remove the IPMA cover.
Disconnect the electrical connector.
Release the tabs and remove the IPMA.
Installation
Install the IPMA
Install the lower tabs...
Special Tool(s) /
General Equipment
303-1521Alignment Tool, Crankshaft Position SensorTKIT-2010C-FLM
303-1686Holding Tool, Camshaft
303-1689Holding Tool, Crank Damper
303-507Timing Peg, Crankshaft TDCTKIT-2001N-FLMTKIT-2001N-ROW
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESE-M1C171-A
..
Categories
When these locks are set, you cannot open the rear doors from the inside.

A child safety lock is on the rear edge of each rear door. You must set the child
safety lock separately on each door.
Left-Hand Side
read more