Ford Explorer: Fuel Charging and Controls - 2.3L EcoBoost (201kW/273PS) / Diagnosis and Testing - Fuel Charging and Controls

Ford Explorer 2020-2026 Service Manual / Powertrain / Engine / Fuel Charging and Controls - 2.3L EcoBoost (201kW/273PS) / Diagnosis and Testing - Fuel Charging and Controls

General Equipment

Ford diagnostic equipment

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

For a PCM DTC,
REFER to: Electronic Engine Controls (303-14A Electronic Engine Controls - 2.3L EcoBoost (201kW/273PS), Diagnosis and Testing).

For driveability symptoms without a DTC, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 3, Symptom Charts.

Description and Operation - Fuel Charging and Controls - System Operation and Component Description

System Operation For System Operation, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 1 Description and Operation. Component Description For Component Desc..

Removal and Installation - Fuel Pump Driver Module (FPDM)

Removal All Vehicles NOTE: The fuel pump driver module is located on the bottom side of the left front floor panel, above the sound insulation panel...

Other information:

Ford Explorer 2020-2026 Service Manual: Description and Operation - Parking Aid - System Operation and Component Description

System Operation Parking Aid - Audible System Diagram without 360 Degree View Camera Item Description 1 PAM 2 LHR outer sensor 3 LHF outer sensor 4 LHF inner sensor 5 RHF inner sensor 6 RHR outer sensor 7 RHF outer sensor 8 RHR inner sensor 9 LHR inner sensor 10 Parking aid disable switch 1..

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Driver Front Seat Module (DSM)

Removal NOTE: Seat with DSM (driver front seat module) and SCME (front seat climate control module) shown, without similar. NOTE: This step is only necessary when installing a new component. NOTE: The PMI (programmable module installation) process must begin with the current DSM (driver front seat module) installed...