Ford Explorer: Collision Warning and Collision Avoidance System / Diagnosis and Testing - Collision Warning and Collision Avoidance System

Ford Explorer 2020-2026 Service Manual / Electrical / Electronic Feature Group / Collision Warning and Collision Avoidance System / Diagnosis and Testing - Collision Warning and Collision Avoidance System

Symptom Chart

Symptom Chart: Forward Collision Warning

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

Symptom Chart

Condition	Possible Sources	Actions
The forward collision warning system is inoperative	IPC	REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes, Diagnosis and Testing).
PRE-COLLISION ASSIST NOT AVAILABLE SENSOR BLOCKED SEE MANUAL message in the IPC message center	IPMA	REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes, Diagnosis and Testing).
FRONT CAMERA LOW VISIBILITY CLEAN SCREEN or FRONT CAMERA MALFUNCTION SERVICE REQUIRED message in IPC message center	IPMA	VERIFY the forward-looking camera is not obstructed or weather conditions are not limiting the function of the camera. If the camera is operating correctly, DIAGNOSE concerns with the IPMA. REFER to: Lane Keeping System (419-07 Lane Keeping System, Diagnosis and Testing).
Too many forward collision warning events occur	A MyKey® restricted key is in use	VERIFY a MyKey® restricted key is in use. With an admin key, VERIFY forward collision warning system normal operation.

Description and Operation - Collision Warning and Collision Avoidance System - System Operation and Component Description

System Operation ACC With Pre-Collision Assist Item Description 1 ACM 2 RCM 3 CCM 4 IPC 5 BCM 6 GWM 7 ABS mod..

Side and Rear Vision

Other information:

Ford Explorer 2020-2026 Service Manual: Description and Operation - Direct Current/Alternating Current (DC/AC) Inverter - System Operation and Component Description

System Diagram System Operation Network Message Chart Broadcast Message Originating Module Message Purpose Power pack torque status Secondary On-Board Diagnostic Control Module C (SOBDMC) Used to determine if the vehicle is started or if torque is available...

Ford Explorer 2020-2026 Service Manual: Removal and Installation - Manifold Absolute Pressure and Temperature (MAPT) Sensor

Materials Name Specification Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A ESE-M1C171-A Removal NOTE: Removal steps in this procedure may contain installation details. NOTICE: Do not pull the engine appearance cover forward or sideways to remove...